Down Draft My solution

tylerd · Post by **tylerd** » Mon Nov 11, 2019 2:51 am

I bought a Starlab 4x8 back in 2017, it was water table, I converted it to downdraft, this was an extreme process to say the least, but here it is for better or worse. It is complete, and it works awesome! Table is in a small 2x garage in FL on a canal. Here are the Pics.

tylerd · Post by **tylerd** » Mon Nov 11, 2019 2:55 am

Sorry little out of order, the horsie was my first painted project, Thanks for file! for my mother in law back in KC.

tylerd · Post by **tylerd** » Mon Nov 11, 2019 2:57 am

Beginning got removed for some reason?

Post by **weldguy** » Mon Nov 11, 2019 1:04 pm

Very interesting but I don't understand where your exhaust air ends up going?

tylerd · Post by **tylerd** » Tue Nov 12, 2019 8:28 am

4th picture up from the bottom, it comes up from the trench and out the side of the house...see my ghetto ductwork?

Post by **weldguy** » Tue Nov 12, 2019 9:34 am

tylerd wrote: ↑Tue Nov 12, 2019 8:28 am 4th picture up from the bottom, it comes up from the trench and out the side of the house...see my ghetto ductwork?

Ghetto ductwork

Ah I see it now, interesting setup, you sure put the time in on that one

Post by **acourtjester** » Tue Nov 12, 2019 9:59 am

Good thing the exhaust is high on the wall to the raccoons from nesting in there

racecar366 · Post by **racecar366** » Tue Dec 17, 2019 3:03 pm

what fan did you get and what did it run you ?we have a 4x4 table and are looking at doing the same as you did. looks great

tylerd · Post by **tylerd** » Wed Dec 18, 2019 2:30 am

It is a Dayton 4TM85, I got it off Ebay for 400 I believe, had minor bend on flange but was straightened easily. Keep looking you will find a deal!

Down Draft My solution

Down Draft My solution

Re: Down Draft My solution

Re: Down Draft My solution

Re: Down Draft My solution

Re: Down Draft My solution

Re: Down Draft My solution

Re: Down Draft My solution

Re: Down Draft My solution

Re: Down Draft My solution