Jet Tool- Options

[4x8_Plasma]

New jet tools / edit jet tools

I wanted to edit and also create a new jet to cut 14ga.

Someone sent me a picture of their sheetcam jet tool layout so I went to edit my tool and found that the jet tool screen options are different.

The one I was sent had a lot more options than my sheetcam tool setup did.

I have attached two pictures.

One pictures shows the screen sent to me that has more options.

Second picture is the screen from my sheetcam that has less options.

[djreiswig]

If you're using a different post processor there could be more or less settings in the tools. It looks like the second picture is probably using a CandCNC post.

[acourtjester]

Could it be the top is from Linux I looked at both TNG and Developer versions in windows