Vicon Table Replacement Stepper Motor(s)

[capnjb]

Hi!

Looking for a bolt in replacement stepper for our 10x5 Vicon Plasma table.

The Vexta supplier says they are discontinued and the replacement requires a new driver but the bigger deal is the shaft and bolt pattern are different. The motor is physically larger we are advised.

Therefore, we are looking for a replacement elsewhere or if someone has new old stock on the shelf.
Either of the following will fit & work:
Vexta stepper motor UPH296H-AA (UMD296H-AA) 2 phase 1.8 / step dc 2amp 1.0 Ohm <- Original
Vexta stepper motor UPH299H-AA (UMD299H-AA) 2 phase 1.8 / step dc 2amp 1.5 Ohm

Any information would be helpful and if you hove on the shelf unused let us know. Please PM me with contact info.

Thanks,
Jon

[plasmanewbie]

Check out this link and you may find what your looking for https://www.applied-motion.com/products/stepper-motors

I have worked with these motors and they are of good quality

[capnjb]

@plasmanewbie Ok Will Do!

Thanks

[plasmanewbie]

@plasmanewbie Ok Will Do!

Thanks

Good luck