post prossesor in sheetcam for THC with Ohmic

[ironridge]

I running sheet cam and mach3. I have recently set up a ohmic sensor to use to detect top of sheet metal for my plasma prior to each pierce, and it works great. The only issue that I have now is since I change to post processor "Mach 3flame with THC" to do the zero ref. I can not go and run from a certain line number if something went wrong such as a miss fire on plasma in Mach3. Before I user just "mach3 " post processor and if I need to run from any line I could just pick run from line # and would start from there with no issues. Is there a better post processor I should be using? Thanks in advance for any help.

[East German]

Hello,

I also had the problem. Guilt was with me the G31for the touch off.
I use the G28.1that works with me!
Start from here is not a Problem.

Peter

[ironridge]

Thanks. How do I go about changing from the g31 to a 28.1. Is there a other post processor or you edit a post processor? New at this so unsure best way yet to change and try.

[East German]

Hello,

Post Processor DTHC-HYT-TAP_SoftPierce+Marker-rev 11J

from the CandCNC website is very good!

https://www.candcnc.com/downloads/

Peter