Can somebody give me dimension on a Dynatorch table?

[calsdad]

I bought a used Dynatorch XLR8 4x4 table - and I'm going to be heading out to pick the thing up tomorrow.

I would like to put the Gantry assembly into the back of my truck - but I'm not sure if it's going to fit.

So what I'm wondering is - if somebody has an XLR, XLS, or XLE system - if they could take a measurement
of the * total * length of the gantry and give me some numbers. What I'm looking for is the length of the gantry
- outside edge to outside edge.

If you don't have a 4ft wide table but have a 5ft or other width table - telling me the width of your table and
then the length of the gantry would also be really helpful. I could figure out the length of the gantry on the
4ft wide machine from there.

A total height measurement would be greatly appreciated too.



I tried to get this information out of Dynatorch and from the seller of the machine - and they've all been less than helpful.

Thanks!!

[tcaudle]

Better hope it runs and cuts. Based on not even being able to get dimensions, getting support might be an issue.

[Dawgonhawg]

Hard to believe Dynatorch tech support will not help you. Have always got great support from there. If fact just got my second Dynatorch about 2 months ago. Ask for Russell or Mike...they will help you.