Tip Size Default value 45 amp

[exapprentice]

Hi everyone

just asking if there is a way of editing / changing the "Tip Size" from the default 45
I have tried to edit the "PLASMA TOOL" where it states "Tip size - amps" but it always seems to defaults back to 45 has anyone else noticed this or found a way of changing the value

[djreiswig]

I think the tip size setting just displays in the code. I don't believe it actually does anything as far as setup. One of the posts has an error where two numbers are swapped and it won't allow the setting to stick.

[sphurley]

https://www.candcnc.com/supportforum/vi ... size#p8473