Price check

Ghettoman · Post by **Ghettoman** » Fri Oct 06, 2017 9:25 am

30x16 1/4 thick. Customer supplied the metal. I'm pretty new so majority of my time was on drawing and adjusting name /dates how he wanted them. What would some of you "pro's" charge? Thanks

Shane Warnick · Post by **Shane Warnick** » Fri Oct 06, 2017 1:18 pm

How many inches of cut and how many pierces?

Bobkovacs · Post by **Bobkovacs** » Fri Oct 06, 2017 7:52 pm

Depends on how much time you spent screwing with the design, but I'd be looking for about $110

Nacs Fab · Post by **Nacs Fab** » Wed Oct 11, 2017 10:52 am

I would suggest something to you - back away from using customer supplied steel. Steel is something you should be able to mark up somewhat and make a profit off it. Only project where I used customer supplied steel was when they brought 3 sheets of 11 gauge P&O steel with absolutely no rust.

Post by **chevybythesea** » Wed Oct 11, 2017 12:26 pm

Yes, I too would stay away from customer provided materials. What happens if you mess up? Better to use your own, mark it up as Nacs said, and not stress about it.

That design, in 1/4" for me would be $75-100, including material.

Ghettoman · Post by **Ghettoman** » Wed Nov 15, 2017 1:43 am

Thanks everyone. I didn't notice any responses till now... Guessing I need to check back more often

Price check

Price check

Re: Price check

Re: Price check

Re: Price check

Re: Price check

Re: Price check