DHC Software ?

[steveb3906]

I recently bought a used Plasmacam DHC setup. Working well before moving to my shop.

After the move, the computer hard drive went bad, no recovery on it. I believe it was running 3.11 software. naturally no disk or backup

My question is does the new DesignEdge software run the DHC version controller/table ? Or is it only for the DHC2 controller/table ?

Thanks,

-Steve

[PlasmaMac]

The designedge upgrade can go on a dhc machine. Another thing to consider is the upgrade kit that plasmacam recently made available that would essentially convert your older DHC system in a New Dhc2. That upgrade kit will also come with the designedge upgrade at a discounted price.

Best thing to do would be to call in and talk to one of the guys in there.

JAG