Table slide

[jim fry]

So I went in and build a parts slide into my table. It works great when little parts fall thru the table they slide down to the bottom. So I just lift the door and there right there. Even if it is just drop and metal dust. A lot of that slides down to the bottom so that help me keep my table nice and clean. When I design the slide I to added step to putting a big vacuum on the table to suck the dust out. That will be next month. So we will have to wait and see if that works good.

[fab-man]

Nice job Jim, I hate sifting through my scrap heap to find a part I just cut!!!

fab-man

[jim fry]

Yea I i hated trying to reach my arm to get hot part. I hope to get a down draft set up in it soon

[ce offroad]

how is this working out so far? I have this in my plans...