Corner squiggles on my dynatorch xls

[Dynatorch78]

Whenever my machine takes a corner at 120IPM or above, I get a squiggly line for about 2 " then it becomes straight again. I turned the corner intensity all the way down and slowed the speed down as much as possible also. I don't want to be smoothing out these squiggles forever. Does anyone have any Advice? BY the way, it is a new Dynatorch xls .

[Gamelord]

This is a common issue, something is loose, either your gantry has some play, your torch has some play or your slats are shaking in the table.

[TMC]

Dynatorch78, I have been down this road myself with my Dynatorch. Don't assume anything is wrong with your gantry. I would suggest calling Michael Garrett, he helped me out a bunch. I have a SuperB so I can't help with your table much. Good luck!