font help!
-
hooked
- 2 Star Member
- Posts: 55
- Joined: Wed Oct 17, 2012 12:37 pm
font help!
hey folks, have noticed lots of us use different font packages, do you all have a fav that cuts well and whats the best way to transfer to dxf for cutting?? thanks in advance, hooked
-
jmsrbrt
- 3 Star Member
- Posts: 382
- Joined: Mon Dec 08, 2008 5:24 pm
- Location: San Marcos, TX
- Contact:
Re: font help!
Font...anything rounded. Easy to clean up.
Torchmate 2 with ATHC & Water table
Corel 12, Turbo Cad
TD Cutmaster 51
San Marcos, Texas
Corel 12, Turbo Cad
TD Cutmaster 51
San Marcos, Texas
-
JJsCustomDesigns
- 3.5 Star Member
- Posts: 583
- Joined: Thu Jul 07, 2011 12:29 pm
- Location: Nebraska
Re: font help!
i usually use Georgia Bold font. It looks nice. There is typical bridge work tho.
"There are bigger things planned for you in your life, be patient"
Im on the prowl for a good used Hypertherm Plasma with hand torch.
PM me with details
Thanks
Im on the prowl for a good used Hypertherm Plasma with hand torch.
PM me with details
Thanks
-
hooked
- 2 Star Member
- Posts: 55
- Joined: Wed Oct 17, 2012 12:37 pm
Re: font help!
hey jj i guess what i was looking for truely was where to purchase fonts that work? and as you have stated they will all need clean up once i have what im looking for .JJsCustomDesigns wrote:i usually use Georgia Bold font. It looks nice. There is typical bridge work tho.
-
JJsCustomDesigns
- 3.5 Star Member
- Posts: 583
- Joined: Thu Jul 07, 2011 12:29 pm
- Location: Nebraska
Re: font help!
Theres TONs of sites that offer free fonts. The one i use the most is DaFont . There is usually a banner on this forum that advertises 10,000 fonts. But i dont see it today.
"There are bigger things planned for you in your life, be patient"
Im on the prowl for a good used Hypertherm Plasma with hand torch.
PM me with details
Thanks
Im on the prowl for a good used Hypertherm Plasma with hand torch.
PM me with details
Thanks
-
Rustic Raider Iron
- 1 Star Member
- Posts: 20
- Joined: Fri Dec 07, 2012 3:22 pm
Re: font help!
Just got a first table using HYCAD to draw images and text. Having trouble knowing what fonts to use, do they all have to be cleaned up? When I convert to dxf and open up in sheetcam have to many lines show up and tons of little cuts. Any advise that could be sent my way would be great. Thanks for the help.
Matt
Matt
