3510 gehl bucket ears

[Zippo]

Anyone ever seen the layout for weld on bucket ears for 3510 gehl skid loader?

[Joe Jones]

Are you unable to get hold of a bucket to take the physical measurements yourself?

Joe


.

[Joe Jones]

Is this the bucket you are talking about?

Perhaps you could get the company to send you the dimensions, or a diagram, or a DXF file of the parts?

Joe

https://store.germanbliss.com/gehl-skid ... es-buckets

.

[adbuch]

Anyone ever seen the layout for weld on bucket ears for 3510 gehl skid loader?

I haven't seen a layout or cad file, but these shouldn't be too hard to draw up if you can supply some basic dimensions as to fitment.
David

Gehl_Weld_On_Ear_Adapters_3__81989.1618593462.JPG

[Zippo]

Sorry to say I don't have the 3510 bucket or I would get the specs myself...so shooting blind on them, And as far as germanbliss the parts are discontinued and they have no specs. Guess to stop us from doing reverse engineering

[Joe Jones]

I created this file based on photographic geometry, and some good, old fashioned Kentucky Redneck GUESSIN'

I THINK these will fit just fine.

I am uploading a You Tube a video to show how the file was created. Let me know if they work!

Joe

SKID STEER BUCKET BRACKET JPG.jpg

SKID STEER BUCKET BRACKETDXF.dxf

http://youtu.be/HBGOl6LkBn4

[Zippo]

Thanks Joe I have an starting point now

[Joe Jones]

Remember that the 1 inch hole actually needs to be bigger because you’re going to put a sleeve through it and weld it on both sides so that the pin can go through the sleeves. So the hole should probably be one and a half inches in diameter and then you would get a tube with a 1 inch interior diameter and 1 1/2 inch exterior diameter in order to create the two sleeves.

Joe



.