Spray anti weld spatter on the bottom side of the plate you're going to cutting (the whole plate).Just one coat I spray side to side then up and down.
One can last about 4 8ftx 4ft sheets of metal
you can get it at a weld supply store.
After seeing the results you won't use muriatic acid again.
A can cost about $6.00.
You will be amazed.
Very little if any clean up
Jim
Getting rid of dross or slag the easy way
-
james.davis
- 4 Star Member
- Posts: 1004
- Joined: Mon May 21, 2012 3:58 pm
- Location: spanaway wa.
Getting rid of dross or slag the easy way
You currently do not have access to download this file.
To gain download access for DXF, SVG & other files Click Here
-
TJS
- 3.5 Star Elite Contributing Member
- Posts: 764
- Joined: Wed Nov 26, 2014 1:22 pm
- Location: Fairfield, CT.
- Contact:
Re: Getting rid of dross or slag the easy way
Do you have a water table with this process.
-
james.davis
- 4 Star Member
- Posts: 1004
- Joined: Mon May 21, 2012 3:58 pm
- Location: spanaway wa.
Re: Getting rid of dross or slag the easy way
No I don't. Although it probably wouldn't hurt to give it a try. Only out $6.00.
If you do try it let me know if it works for you.
Thanks
Jim
If you do try it let me know if it works for you.
Thanks
Jim
-
TJS
- 3.5 Star Elite Contributing Member
- Posts: 764
- Joined: Wed Nov 26, 2014 1:22 pm
- Location: Fairfield, CT.
- Contact:
Re: Getting rid of dross or slag the easy way
I have a few cans of anti spatter spray. Not sure if it will wash off or not. I will try it.
