All kinds of FUBAR going on. New Guy needs help

[mkingaz]

Hi everyone,

I have been trying to build this project for about 2 weeks now and just cannot get it drawn up correctly to save my life. Figured it might be time to ask for help. I was trying to union the entire piece and then tried to cut the center out and I was going to layer it on top of plexi-glass and glue it back into place. It would be night to keep it all as one if possible. I was doing a duplicate backing sheet with it.

Can anyone help be get this correct?

MIKEJODYCIRCLE.dxf

custom piece I was trying to make

(310.9 KiB) Downloaded 50 times

MIKEJODYCIRCLE.dxf

custom piece I was trying to make

(310.9 KiB) Downloaded 50 times

[acourtjester]

I looked it over and you have hundreds of short lines and curves that is not way you can do what you want with this drawing.
I would suggest you contact Ben Delap to have him draw a new file.
www.etsy.com/shop/DesignsByDeLap https://www.facebook.com/designs.by.delap

[ctgolfer1]

Hi everyone,

I have been trying to build this project for about 2 weeks now and just cannot get it drawn up correctly to save my life. Figured it might be time to ask for help. I was trying to union the entire piece and then tried to cut the center out and I was going to layer it on top of plexi-glass and glue it back into place. It would be night to keep it all as one if possible. I was doing a duplicate backing sheet with it.

Can anyone help be get this correct?MIKEJODYCIRCLE.dxf

Hey man, I have to totally agree with the above poster, there is way too much going on in there to cut it on plasma, Ben Delap will clean that up and return it to you in a clean file that can be cut. Ben has done a some work for me and it most likely the only way your going to get this cut, he does not charge very much.
Good luck!

[mkingaz]

Thank you both for the input. Much appreciated.