plasma arc do not stops right away

[belloutiplasma]

hello sir
i have a problem with my cnc plasma table
the plasma arc do not stops right away when finishing cutting of a piece
the torch moves to next pierce but torch do not stops right away
i attached a picture of a cutted piece it is supposed to start and end with quarter circle but it continues to cut a little bit more
i will be grateful if you can help me solve this problem
thank you

[weldguy]

Sticky relay in your controller? What equipment are you running?

[acourtjester]

If you are using SheetCam you may have the overcut set with a value.

cut.JPG (59.84 KiB) Viewed 610 times

cut.JPG (59.84 KiB) Viewed 610 times