sheetcam problem ?

superdutypower · Post by **superdutypower** » Fri Jul 22, 2016 5:05 pm

I got some file from free dxf great product but when i load into sheetcam and do the setup (type of metal ga Etc and layers when I get done it put lines in the file that were not there before not sure what the problem is I'm new to all of this .If you could help a newie out that would be great

Post by **acourtjester** » Fri Jul 22, 2016 5:28 pm

Are you attaching lead-in and lead out line. The blue line in SheetCam are rapids and are showing the torch moving between parts. If the new lines are attached where you have a yellow S and a number these are lead in.
If not will you attach a screen shot sowing the lines you are talking about

superdutypower · Post by **superdutypower** » Fri Jul 22, 2016 6:02 pm

Sometime I can just kick myself I had the leadin and leadout set to none when I change them the lines went away I feel like a dumb %#% I over think things to much Thanks for your time this site is the best

Post by **acourtjester** » Fri Jul 22, 2016 6:25 pm

Happy to help

Post by **tnbndr** » Sat Jul 23, 2016 7:15 am

I feel like a dumb %#% I over think things to much

Welcome to the club!!

kbenz · Post by **kbenz** » Sun Jul 24, 2016 2:54 pm

been there. many a time

sheetcam problem ?

sheetcam problem ?

Re: sheetcam problem ?

Re: sheetcam problem ?

Re: sheetcam problem ?

Re: sheetcam problem ?

Re: sheetcam problem ?