Price Check
-
bwjls
- 1.5 Star Member
- Posts: 48
- Joined: Thu Mar 04, 2010 2:23 am
- Location: Sulphur, OK
- Contact:
Price Check
What would you charge for this sign? It is double sided cut from 10 gauge steel and a solid center piece of 16 gauge it is 4' wide x 6' tall it has 3,500 inches of cut and 165 pierces it will have 1/2" standoffs on both sides. Thanks
-
rdj357
- 4 Star Elite Contributing Member
- Posts: 1186
- Joined: Sun Mar 11, 2012 4:40 pm
- Location: Tahlequah, OK
Re: Price Check
$975 + finish and fab costs.
Robert Johnson
PlasmaCAM GURU & Instructor
I am not affiliated with PlasmaCAM, Inc. in any way. I offer training on their equipment and software. All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them are for nominative purposes only and does not imply any affiliation with or endorsement by them.
PlasmaCAM GURU & Instructor
I am not affiliated with PlasmaCAM, Inc. in any way. I offer training on their equipment and software. All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them are for nominative purposes only and does not imply any affiliation with or endorsement by them.
-
bwjls
- 1.5 Star Member
- Posts: 48
- Joined: Thu Mar 04, 2010 2:23 am
- Location: Sulphur, OK
- Contact:
Re: Price Check
Thanks for the information I was thinking about $1,500.00 with it being powder coated. So it looks like we were close.
