Just Getting Started

Largemouthlou · Post by **Largemouthlou** » Sat Sep 04, 2010 9:14 pm

Just wanted to say hello to everyone, Been lurking for a while and just now starting to build my table..

Have read many good informitive post here and will have ? to start but hope to help in the future!!

Hope everyone has a great, safe weekend

Louis

AnotherDano · Post by **AnotherDano** » Sat Sep 04, 2010 10:05 pm

Welcome LargeMouth,

That moniker sounds familiar. Are you a powder coater?

Dano

Largemouthlou · Post by **Largemouthlou** » Sun Sep 05, 2010 6:26 am

Another familure face!!

Yes, we have talked on PBTP and 365.. Just started that as well

AnotherDano · Post by **AnotherDano** » Sun Sep 05, 2010 9:21 am

Largemouthlou wrote:Another familure face!!

Yes, we have talked on PBTP and 365.. Just started that as well

In that case, DOUBLE welcome.
You'll like the folks on this forum. Great people.
It's the cutters version of the P-365 group; The best and most helpful people in the business.

Post by **Streetwerkz** » Wed Sep 15, 2010 11:29 am

man, whats going on here a migration?

Largemouthlou · Post by **Largemouthlou** » Wed Sep 15, 2010 8:39 pm

Yup, looks like everyone has been moving around

Eagle Mtn Metal Works · Wed Sep 15, 2010 11:54 pm

Hi all Rod from AZ I got my PC table in April and just now getting it put together, and found out today that I have a bad controller box. Go figure. Lots of good stuff on this site. Hope to get to know a lot of you all.

Largemouthlou · Post by **Largemouthlou** » Thu Sep 16, 2010 5:26 am

Welcome aboard Rod... I've had mine for about 3 months as well before getting started on assembly.. sure not looking foward to any problems.. Hope all goes good for ya, lots of info and good people here

Just Getting Started

Just Getting Started

Re: Just Getting Started

Re: Just Getting Started

Re: Just Getting Started

Re: Just Getting Started

Re: Just Getting Started

Re: Just Getting Started

Re: Just Getting Started