question for ya'll

Post by **ironhorse** » Sun Jun 16, 2013 3:33 pm

I do all my cutting with 14 gauge. I run plasmacam with hypertherm power max 30. My brother in law wants me to cut some 1/4" mild steel. Can someone give me some pointers on settings please.

Thank you in advance,

Greg

JJsCustomDesigns · Post by **JJsCustomDesigns** » Sun Jun 16, 2013 8:30 pm

....post deleted....

AnotherDano · Post by **AnotherDano** » Mon Jun 17, 2013 12:38 am

I have the same machine combination and have cut 1/4 treadplate with very good results.
Sorry, but the settings are saved on the shop machine and I'm at home.

I'll try to remember to make a copy and post them tomorrow.

Dano

Post by **jimcolt** » Mon Jun 17, 2013 10:16 am

Here are the mechanized settings. These are from the Powermax45 operators manual for use with the Powermax30 consumables.

Jim Colt Hypertherm

ironhorse wrote:I do all my cutting with 14 gauge. I run plasmacam with hypertherm power max 30. My brother in law wants me to cut some 1/4" mild steel. Can someone give me some pointers on settings please.

Thank you in advance,

Greg

AnotherDano · Post by **AnotherDano** » Mon Jun 17, 2013 8:40 pm

AnotherDano wrote:I have the same machine combination and have cut 1/4 treadplate with very good results.
Sorry, but the settings are saved on the shop machine and I'm at home.

I'll try to remember to make a copy and post them tomorrow.

Dano

This worked for me;

: Settings for .25 plate.jpg (143.05 KiB) Viewed 1438 times

: Settings for .25 plate.jpg (143.05 KiB) Viewed 1438 times

: Settings for .25 plate example.jpg (134.96 KiB) Viewed 1438 times

: Settings for .25 plate example.jpg (134.96 KiB) Viewed 1438 times

Post by **ironhorse** » Wed Jun 19, 2013 2:00 am

hi guys, thank you so much for all the help here. it means a great deal.

Greg

question for ya'll

question for ya'll

Re: question for ya'll

Re: question for ya'll

Re: question for ya'll

Re: question for ya'll

Re: question for ya'll