Need Enroute help

[Mr.Dirt]

I am trying to cut smaller pieces that fall out before the cuts are all done.
What is the best way to solve this? I use Enroute.

Thanks

[Mr.Dirt]

Any help out there?
?

[Gamelord]

Not sure if this is what you are asking, but if the piece falls out before you get all the rest of the cuts done, this is usually a layer issue. You need to set your pieces up so that it cuts the inside pieces first, then cuts the outside pieces. Without knowing what software you are using, it is hard to say how to do this.

[Mr.Dirt]

Enroute 4 is the software that I use.

Thanks