Duramax machine torch

Hypertherm Plasma Cutter discussion forum.
Post Reply
Ironman
2 Star Elite Contributing Member
2 Star Elite Contributing Member
Posts: 82
Joined: Fri Jul 24, 2009 12:01 am
Location: Warburg, Alberta

Duramax machine torch

Post by Ironman »

A while back I bought the Duramax upgrade machine torch for my Pcam table.
Now that I have upgraded my Hyper 1250 plasma torch from the T-80 torch to the Duramax machine torch, I was left with a pile of tips for the T-80 hand torch. I want the 80 amp tips - good for hand cutting some object.
But I have about 2 dozen new tips besides the 80's, mostly Finecut tips for the T-80.

The Duramax machine torch is just great, but I hate to toss out new tips. So I fired up the caliper, and started to measure things. I figured out that the only difference physically was the hole in the Duramax shield that the tip goes through was 10 thou smaller than the older shield #120929.

So I did what any self-respecting machinist would do, I threw a spare shield into the lathe and cut out that pesky 10 thou. Now the old T-80 tips fit into the new Duramax torch.
But can she cut? I cut 500 inches on one old type Finecut today and it looks untouched, and the only thing I noticed you had to raise the cutting speed at least 10 inches. It lit and cut very nicely.
The Duramax and the T-80 Finecuts are pictured for comparison. I will stay with the Duramax tips when I use these up, there is no price advantage, but little downside to modifying a torch shield.

Sorry in advance, Jim Colt, I know it's probably not perfect, but it works.
jimcolt
5 Star Elite Contributing Member
5 Star Elite Contributing Member
Posts: 3087
Joined: Mon Jul 20, 2009 11:18 pm
Location: North Carolina

Re: Duramax machine torch

Post by jimcolt »

I probably would have done the same....good work!

Jim Colt
Post Reply

Return to “Hypertherm Plasma Cutters”