1/16th brass

Post by **redfarm** » Sun Feb 05, 2012 3:13 pm

had a customer call today wanting to cut 1/16th brass. I looked at the cut charts and kinda thought the 18ga. SS setting with fine cuts (1250/T-80) would be a good place to start, does anybody have a better suggestion and/or practical experience with this material. thanks.

Post by **jimcolt** » Sun Feb 05, 2012 4:02 pm

Use the same pierce height and cut height...likely the speed will be slower than on stainless.

Jim Colt

Post by **redfarm** » Sun Feb 05, 2012 4:32 pm

Thank you very much. This job could be a real treat.

Fish1la · Post by **Fish1la** » Fri Feb 10, 2012 9:28 am

were can i find a cut chart im new and have no idea how to set the speed or feed need help please

Post by **mdwalker** » Fri Feb 10, 2012 9:52 am

Fish1la wrote:were can i find a cut chart im new and have no idea how to set the speed or feed need help please

Go to hypertherm's website & download the manual for your machine. It should have cut charts in it.

https://www.hypertherm.com/Xnet/library ... ?locale=en

Fish1la · Post by **Fish1la** » Fri Feb 10, 2012 11:34 am

thank you i got it i dont know how to use it yet but i think it will help

1/16th brass

1/16th brass

Re: 1/16th brass

Re: 1/16th brass

Re: 1/16th brass

Re: 1/16th brass

Re: 1/16th brass