Purchase a DesignEdge License WITHOUT a table?

[Joe Jones]

I am not sure if this is possible, but I believe PlasmaCam might sell a DesignEdge license ALONE, without a table or Go Torch machine. I will have to call them tomorrow to ask about this. It would greatly increase their chances of selling tables, but PlasmaCam may no longer sell the software independent of the tables, and frankly, I don't know IF they ever did.

A DesignEdge license with Advanced Design Upgrade, Automatic Nesting Upgrade, and perhaps 3D capability would be a nice package.

Joe


.

[adbuch]

Plasmacam offers a Design Edge perpetual license (stand-alone) for around $3k. Add in an additional $1K for the Advanced Design upgrade. So around $4k total. This software will not run a table, but will import g-code and convert to drawing paths.

David

[adbuch]

Here are some screen shots showing the Settings Tabs for a recently purchased Design Edge stand-alone license.