Broken lines when opening DFX files

[Joe Jones]

After looking at the SheetCam again I am completely wrong with my interpretation for a solution

A solution to what?

Joe

[adbuch]

I was able to achieve success editing the original posted dxf file with LightBurn, exporting as dxf, and importing to SheetCam. I tried several different combinations of operations in LightBurn. These included combinations of Close selected paths with tolerance, auto join selected shapes, and Auto group. I will need to go back and try to recreate the exact order I applied these tools in. In any case, I was able to get a usable file.
David

butterfly 3d from LightBurn.dxf

(107.81 KiB) Downloaded 6 times

butterfly 3d from LightBurn.dxf

(107.81 KiB) Downloaded 6 times

[adbuch]

I went back to take a look and here is how I edited the original dxf file using LightBurn to produce a result that will work with SheetCam.
David

Butterfly 3D - autojoin plus close selected paths.dxf

(105.32 KiB) Downloaded 7 times

Butterfly 3D - autojoin plus close selected paths.dxf

(105.32 KiB) Downloaded 7 times

I was going to post the actual LightBurn file, but apparently this site does not support the .lbrn2 file type. So here is the download link to my file.
Hover your mouse pointer over the window below and click on the pop-out button.

[acourtjester]

As usual Great show David. and the solution.

[adbuch]

As usual Great show David. and the solution.

Thanks Tom! It was trial and error until I got it right, but now it's nice to have it documented for future reference.

Have fun!!

David