1/4" cuts last night

[Wine Country]

My Hypertherm Powermax 1000 w/T60M torch and Dynatorch table are dialed in now after experimenting with speed and cutting heights finally. Here is a shot of some 1/4" plate I cut last night. Dross was practically non existant and this shot is right after being glass beaded. I have been having the same luck with thinner gauges as well,with only very minimal dross where the slats are located.

[I Lean]

Looks great! I love my Hypertherm.

Would you mind sharing your cut settings, just for fun comparison?

[I see spots]

I've heard of this "dross free zone".......


glad you found it.

I haven't

[malkintent]

i have the setup cepy the table.
what cut height and speed?
what amps and air?

im pulling my hair out

wel if i had any!

[Fish1la]

hi im new and i would like to know how do you set the speed and feed rate i have no idea please help

[jimcolt]

What type of cutting machine (brand and model) and plasma system (brand and model) do you use.....with that info we can probably offer good advice.


Jim Colt

hi im new and i would like to know how do you set the speed and feed rate i have no idea please help

[Fish1la]

i have a Eastwood versa cut with high frequency inverter tech. modle # 12740