payloader coupling

[Clyde8375]

hi i am looking for a drawing or dxf of the caterpillar fusion payloader hook blanks if anyone has one that would be much appreciated or a good way to draw them as there are fairly specific angles.

[hardworker]

That part could easily be traced an scaled to fit using Inkscape. Is it the wedge style locking or pin locking?

[Clyde8375]

Yes the wedge style with the pins that lock in the bottom I have never used Inkscape I just got a new table with flashcut and have been trying to figure out how to trace it/ draw it in there but the program is new to me

[plasmanewbie]

Can you reply and attach your drawing so we can have a look?

[Clyde8375]

These were the pics I was going off if they will be out of 1.5” thick steel I think these dimensions are close but I can measure one for sure later

IMG_3176.png

IMG_3175.png

[adbuch]

A simple example to get you started.
David

https://photos.app.goo.gl/tMuoioteEvxe6Uup8

a simple example.jpg

[hardworker]

Take a look at the Inkscape forum on this site or do a simple search of Inkscape, your guaranteed to find all the step by step tutorials you’ll need to successfully complete your part. If you get hung up anywhere along the way many members here will help. Plenty of info and knowledge available to be successful.

[Clyde8375]

Awesome I appreciate the help I am very close to getting them to fit right just a few more tweaks.

[adbuch]

Awesome I appreciate the help I am very close to getting them to fit right just a few more tweaks.