back into just to sell it

[rock4xfab]

After almost 10 yrs of not using my table, I have a potential buyer for it. I had to relearn it, and pull from storage dust off the cobwebs and give it a whirl. After 2 weeks of brain cramps I went in for the kill, fruits of my labor have paid off with making new toolsets and test cuts again. Almost sorry to see it go. But here's what I have been doing this past week. The steam punk was jacked up I had no lead set, and lost the last portion of the cut. Don't know why. THC doesn't appear to be tracking but its getting signals to move. IF I just lock it out it works fine, the thick plate was 5/16" top side nad bottom turned out well.

IMG_1966.jpg

IMG_1962.jpg

IMG_1961.jpg

IMG_1956.jpg

IMG_1955.jpg

70943580051__67DE8B8C-4EC4-41CB-8C53-189D94804B32.jpg

[adbuch]

Those look like nice clean cuts to me. Good luck with your sale.
David

[weldguy]

Agreed... those cuts look very good. I expect with a little more time you would have been back up to 100% with it. Not sure about your THC issues though, sorry. THC can be pesky at times. Good luck with everything, I am sure you will miss it.

[abmetal]

Did you design that steampunk file. That sure is neat.

Allen

[rock4xfab]

No I found a JPG and paid a guy to replicate it. I was going to make some end tables under glass and never got around to it.

[rock4xfab]

I know I saw one like it here on the forum years ago. that the guy made a coffee table.