Anyone know if a machine torch from a HP45 will work on an HP65.
Does an HP65 have the same connections as the HP45 for CNC Interface?
TIA
Machine Torch Matchup 45 to 65
-
tnbndr
- 4.5 Star Elite Contributing Member
- Posts: 1688
- Joined: Mon Jan 09, 2012 4:30 pm
- Location: New Berlin, WI
- Contact:
Machine Torch Matchup 45 to 65
Dennis
LDR 4x8, Scribe, DTHCIV
Hypertherm PM45, Macair Dryer
DeVilbiss Air America 6.5HP, 80Gal., 175psi, Two Stage
16.9scfm@100psi, 16.0scfm@175psi
Miller 215 MultiMatic
RW 390E Slip Roll (Powered)
AutoCAD, SheetCAM, Mach 3
http://ikescreations.com
LDR 4x8, Scribe, DTHCIV
Hypertherm PM45, Macair Dryer
DeVilbiss Air America 6.5HP, 80Gal., 175psi, Two Stage
16.9scfm@100psi, 16.0scfm@175psi
Miller 215 MultiMatic
RW 390E Slip Roll (Powered)
AutoCAD, SheetCAM, Mach 3
http://ikescreations.com
-
rdj357
- 4 Star Elite Contributing Member
- Posts: 1185
- Joined: Sun Mar 11, 2012 4:40 pm
- Location: Tahlequah, OK
Re: Machine Torch Matchup
Hi Dennis - the original T45M torch will not work on the Powermax 65. However if a Duramax torch was purchased for use on the old Powermax 45 then it would work on either machine.
The CPC connection on the PM45 has a preset divided arc voltage of 50:1 - the PM65 will have (or require a kit for) an internal divider that is adjustable. If you use the 50:1 currently or just use the trigger/start-stop circuits then it will come factory default to that arc voltage.
The CPC connection on the PM45 has a preset divided arc voltage of 50:1 - the PM65 will have (or require a kit for) an internal divider that is adjustable. If you use the 50:1 currently or just use the trigger/start-stop circuits then it will come factory default to that arc voltage.
Robert Johnson
PlasmaCAM GURU & Instructor
I am not affiliated with PlasmaCAM, Inc. in any way. I offer training on their equipment and software. All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them are for nominative purposes only and does not imply any affiliation with or endorsement by them.
PlasmaCAM GURU & Instructor
I am not affiliated with PlasmaCAM, Inc. in any way. I offer training on their equipment and software. All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them are for nominative purposes only and does not imply any affiliation with or endorsement by them.
