DesignEdge Line Break Location Settings Issue

[RONWB]

Hey newcomer here. Im having a problem that I am hoping someone can help me with. I am using the Design Edge software , previously when I used the Break option it would allow me to break the line exactly where I clicked on the line. Yesterday it started placing the break almost an inch away from where I click , if it even lets me do it. I have not changed any of my settings so I am not sure what is going on. Can any one guide me in how to fix this please?

[weldguy]

I am not at all familiar with DesignEdge however I am wondering if it will only allow you to break at a node and it is moving your break point to the nearest node from your selected location.

[RONWB]

Actually right after I posted this I kept researching on videos and found the answer. And you are correct it was set on node's break. Thank you so much for your response though I really appreciate it.

[adbuch]

Hey newcomer here. Im having a problem that I am hoping someone can help me with. I am using the Design Edge software , previously when I used the Break option it would allow me to break the line exactly where I clicked on the line. Yesterday it started placing the break almost an inch away from where I click , if it even lets me do it. I have not changed any of my settings so I am not sure what is going on. Can any one guide me in how to fix this please?

nodes.jpg

[RONWB]

That is exactly what happen thank you!!!!!!

[adbuch]

That is exactly what happen thank you!!!!!!

[weldguy]

Your welcome, glad you were able to it resolved. Have a great weekend!