Lead in and pierce point help

[HCmillertech]

This file has 2 pierce points that cut the good piece you will see in the picture. How do I move them back to the drop where all the other ones are? Not sure how this happened but I can not get them to change.

Thanks

IMG_2093.jpg (53.73 KiB) Viewed 673 times

IMG_2093.jpg (53.73 KiB) Viewed 673 times

[adbuch]

Please post your file so we can have a look. It would also be helpful to know exactly what cam software you are using. Also more screen shots of the complete cut paths would be good.
David

[djreiswig]

Check those paths. I'm guessing you have a gap somewhere causing them to be open. If you are using SheetCam you can turn on the path end markers and it will show white dots where the paths end.

[adbuch]

Check those paths. I'm guessing you have a gap somewhere causing them to be open. If you are using SheetCam you can turn on the path end markers and it will show white dots where the paths end.

[HCmillertech]

File attached.

Thanks

Shield (1).svg

(52.97 KiB) Downloaded 42 times

Shield (1).svg

(52.97 KiB) Downloaded 42 times

[ROKCRLER]

You have unjoined nodes.
Try this file.

Here is a video on joining nodes https://plasmaspider.com/viewtopic.php?f=77&t=34315

Shield1.JPG (86.63 KiB) Viewed 661 times

Shield1.JPG (86.63 KiB) Viewed 661 times

Shield (1).svg

(30.71 KiB) Downloaded 47 times

Shield (1).svg

(30.71 KiB) Downloaded 47 times

[adbuch]

Here it is as dxf.
David

shield linked.dxf

(285.17 KiB) Downloaded 46 times

shield linked.dxf

(285.17 KiB) Downloaded 46 times

[HCmillertech]

I loaded it into the software and got the same thing.

[adbuch]

I loaded it into the software and got the same thing.

Perhaps you could post a screen shot showing the complete image. Also some shots of your settings pages. I expect some here with experience using Sheetcam will be able to help you out.
David

[cuttinparts]

I have had these issue sin the past also, if I remember correctly it has always been an open path issue. I opened Davids file "shield linked.dxf" and saw no open paths, worked great.

Are you sure you were opening Davids file? It has a unique name from the original file so there should be no confusion on which one your opening unless you renamed the file when you downloaded it.