Nesting in PlasmaCam DesignEdge

[adbuch]

It looks like I do not have a privilege to open my own forum in CAD/CAM section

You are correct. You can start a new thread in one of the existing topics. Here it the link to the cad/cam general section.
David
viewforum.php?f=52

Thank you for the link David!
Yes, I will try to remove old versions.

Adam - My Plasmacam Design Edge software has the capability to nest shapes with the option to generate cut paths at the same time. So this is what I would normally use. But perhaps others who don't have the Design Edge software will be interested in your nesting program.
David

[adbuch]

Here is the control page.
David

Nest Shapes - Design Edge tab.jpg (56.39 KiB) Viewed 5107 times

Nest Shapes - Design Edge tab.jpg (56.39 KiB) Viewed 5107 times

[adbuch]

Adam - I tried your software and really couldn't get it to work. Since you have not been back to the forum, I assume you are no longer interested in feedback or reviews of your program.
David

[Adam Cirkic]

I have made a lot of updates on my nesting software since then. In my case it was better to leave tool-paths to established CAM software. User can make his dgnest_parts.dxf, import this dxf in CAM and then create tool-paths there.