Can I use a different operating system on Plasmacam for a laser?
Thank you
Can I use a different operating system on Plasmacam for a laser?
-
sgauze
- 1/2 Star Member
- Posts: 1
- Joined: Tue Sep 29, 2015 1:25 am
-
adbuch
- 6 Star Elite Contributing Member
- Posts: 10140
- Joined: Thu Sep 21, 2017 5:22 pm
- Location: Tucson, Arizona
- Contact:
Re: Can I use a different operating system on Plasmacam for a laser?
Plasmacam 3.11 and Design Edge both run on Windows and interface to the Plasmacam controller. Are you asking if it is possible to use a different controller/software package to run a Plasmacam table to control a laser?
David
David
-
adbuch
- 6 Star Elite Contributing Member
- Posts: 10140
- Joined: Thu Sep 21, 2017 5:22 pm
- Location: Tucson, Arizona
- Contact:
Re: Can I use a different operating system on Plasmacam for a laser?
Robert Johnson answered your question on the Plasmacam Facebook group.
David
https://www.facebook.com/groups/PlasmaCAM.Tips
David
https://www.facebook.com/groups/PlasmaCAM.Tips
