Looking for help on pricing

Post by **cutnweld** » Thu Dec 17, 2020 4:42 pm

I'm wondering what you all would charge for something like this. 36" square with 16" high side, 1/4" X1-1/2" flatbar arond top for stability. 10 ga material. I'm in Canada but I usually assume the prices i see are USD. I hate pricing and wish it were easy

I cant tell you if cats and hockey mix but hey I do what i am told!

Post by **adbuch** » Fri Dec 18, 2020 1:53 am

I would probably charge between $350 and $450 depending on the cost to finish (spray or powder coat).
David

Post by **DieselFumes** » Fri Dec 18, 2020 12:06 pm

I'd be in the same ballpark as David.

Post by **cutnweld** » Fri Dec 18, 2020 3:27 pm

Thanks! I was thinking 350 but wasn't sure if that was on the high side. Thanks for your time.

Looking for help on pricing

Looking for help on pricing

Re: Looking for help on pricing

Re: Looking for help on pricing

Re: Looking for help on pricing