Hi guys.
Running a hyperthem 85 with 45 amp fine cut consumables, water table on mach 3 control
Wondering if this is about as good as I'll see from it or if there is a way to dial it in even better.
Thanks for any help.
Fine cut on stainless 1.5mm sheet
-
- 1 Star Member
- Posts: 14
- Joined: Fri Jun 12, 2020 4:32 am
-
- 4.5 Star Elite Contributing Member
- Posts: 2182
- Joined: Fri Apr 17, 2009 11:48 am
Re: Fine cut on stainless 1.5mm sheet
Looks pretty good. Are you using lead in's? It looks like it may be piercing on the finished edge but you have little to no dross so it looks good.
-
- 1 Star Member
- Posts: 14
- Joined: Fri Jun 12, 2020 4:32 am
Re: Fine cut on stainless 1.5mm sheet
2mm arc lead ins very happy with the haz and dross
-
- 6 Star Elite Contributing Member
- Posts: 10067
- Joined: Thu Sep 21, 2017 5:22 pm
- Location: Tucson, Arizona
- Contact:
Re: Fine cut on stainless 1.5mm sheet
Looks good. Are you using the Hypertherm recommended settings from the Finecut SS chart?
David
David
-
- 1 Star Member
- Posts: 14
- Joined: Fri Jun 12, 2020 4:32 am
Re: Fine cut on stainless 1.5mm sheet
Sure am David
-
- 4.5 Star Elite Contributing Member
- Posts: 2182
- Joined: Fri Apr 17, 2009 11:48 am