Cutmaster 42 victor, pinout Cnc retrofit

[Trialnterror]

Are there any good schematics of the cutmaster 42? I have a mega v plasma by MillRight and would like to use the cutmaster 42, or would it be better to buy a lasercut 45 or primeweld cut 60 that have the Cnc port already? I’m a electrician for the military so wiring don’t scare me!

Thoughts?

(I searched all over and couldn’t find anything relating)
Paul

[Trialnterror]

Crickets!

[robertspark]

Are there any good schematics of the cutmaster 42? I have a mega v plasma by MillRight and would like to use the cutmaster 42, or would it be better to buy a lasercut 45 or primeweld cut 60 that have the Cnc port already? I’m a electrician for the military so wiring don’t scare me!

Thoughts?

(I searched all over and couldn’t find anything relating)
Paul

Nice table: https://millrightcnc.com/product/mega-v-plasma/
+ affordable option
your delrin runners may take a hammering over time.... but you can get replacements easiliy and cheaply from the openbuilds range of parts + on the slow boat from china

https://www.gasandsupply.com/docs/VIC_D ... -5141).pdf
any help?
schematic back page?

Although this does not relate to your THC it has some interesting interface information on PDF page 14/38 which provides the pinout if your machine has the cnc connector but also the board connections too..
https://minithc.com/pub/MiniTHC2_EN.pdf

[Rodw]

I'm not sure if its available for your machine but TD make an automation interface which gives you a fully populated CPC port. MAke sure you get the one with the divided voltage. as there is another part number that doesn't

[Trialnterror]

Thank you for these links, my manual doesn’t have the schematic! Thanks a lot sir

[Trialnterror]

The delrin rollers are millright proprietary, they designed them. They are 3 times as big as the regular size rollers. So if they do take a hammering either I machine my own or buy from millright.

[robertspark]

The delrin rollers are millright proprietary, they designed them. They are 3 times as big as the regular size rollers. So if they do take a hammering either I machine my own or buy from millright.

Ah, sensible as I'm not sure / confident that the openbuild ones would stand up to a life of plasma blowback at time of pierce.... But keen to learn otherwise

[Rodw]

So the TD interface kit is
Thermal Dynamics 9-8311 automation interface kit
https://www.weldingsuppliesfromioc.com/ ... kit-9-8311
Its hard to find the manual online but it will be included. Best I could find was this
https://www.manualshelf.com/manual/twec ... age-3.html

Screenshot 2020-06-08 at 7.57.09 AM - Edited.png