New to Plasma Spider

[Shoreline]

Hi my name is Jay
I purchased an Arc Light 9600 with a Hypertherm 85.
Hope to draw upon the community for some knowledge.
I have some experience with cnc lathes and mills.
Need to learn more about techniques as it applies to plasma cutting.
Thanks

[plasmanewbie]

Welcome Jay, I am sure you will learn a lot here in a short time and your past experiences should make it an easy learning curve. Best of luck!

[acourtjester]

Welcome aboard Jay there are sections for the Arc Light table and Hypertherm plasma and a search function (upper right) that may give you quick access for some questions. And a large group of users for general question to help and many categories for you to place other questions.
Have fun