Help finding oem consumables

[Dooggins1]

Whats up! I have an everlast 60s plasma and looking for oem type consumables for fine cut type stuff. i have searched the net and everlast website to no previail. Any help would be appreciated.

[tcaudle]

Tecmo makes the torch and consumables .
http://www.tecmo.it/upld/repository/File/02.PT+TH.pdf

There are no "fine cut " consumables for that torch .

Good luck on finding the actual parts listed somewhere for you to buy.

[Dooggins1]

what i meant was a 10-20 amp tip. Im cutting thin stuff and would like a smaller arc (terminology)

[tcaudle]

Then you are SOL. They don't make fine cut or low current tips for that torch .
Since that OEM manufacturer of your torch is one of the largest after market consumables providers too, you can rest assured that no one else would make it
I don't know the feasibility to mount one of the smaller torches on the 60s.

[Brand X]

Looks like they make the tip you want for your PT-60 torch
Tip, Contact Cutting, ø 0.65, 10-20A, Back Striking 51318.06

[tcaudle]

contact cutting ? what does that mean? It appears its designed as a drag tip. dunno what the "flat tip" version is.

[Brand X]

If you look at the machine torch, it shows the same setup. Don't think drag only tip Just need to find one and give it a go.. One thing is a tip might not be perfect for standoff cutting, but sure beats changing a torch out.. Nothing to loose, and everything to gain..